Get Your Plumbing Right: 5 Tips in Installing Water System for the Bathroom

Installing water systems is rarely the first thing that comes to mind when designing a bathroom. This is the number one reason why people don’t get their bathroom plumbing right.

Designing a bathroom is more than just for the aesthetics. It is rather crucial to have your pipes and waterworks carefully planned out before you go further into the bathroom design process. Bear in mind that a bathroom is only as good as its plumbing system, whatever style it may have. To properly guide you in this process, here are five tips in installing bathroom water systems.

Hide all pipeworks.

No luxury bathroom will ever be caught dead with visible water supply and waste pipes. If you have yet to install your pipes, and your bathroom is near completion, you’re in for a bit of trouble. Ideally, if you want your bathroom to look spotless and clutter-free, you may need to remove wall tiles and lift floors just to hide all your pipeworks. This is one of the reasons why a carefully planned out water system goes before the design process of a bathroom.

Install isolation valves.

An isolation valve installed on every single pipe is great for bathroom plumbing systems. This allows you to temporarily shut off any flow of water if you need to do maintenance. Isolation valves can also be incredibly handy in emergency situations, reducing one’s bathroom plumbing problems in great measure.

Opt for flexible pipeworks.

If you want a more cost-efficient approach to installing your bathroom water system, go for flexible pipeworks that no longer require joints. Instead, you can thread these flexible pipes through joists using plastic fittings that are much easier to reconstruct.

Loop hot water systems.

Have you ever wondered why it takes forever to get hot water in the bathroom? It’s probably because your plumbing run is far too long and exhaustive, and your bathroom is at the very end of it.

The most efficient solution for this is to loop your hot water systems by connecting the end of the plumbing, running back to the boiler, and installing a bronze pump to circulate the flow of hot water. If you’re not familiar with this process, you may want to consult with a hot water systems supplier for further assistance. This will save you so much time and effort to get ready in the morning.

Consider electric showers.

Electric showers may not be as cost-efficient and energy-efficient as combi boiler heating systems, but they do make up for convenience. An electric shower has its own water heating system which boils water on demand. So if you treasure your mornings and enjoy your lazy evenings, an electric shower may just be the better option for you.

Conclusion

Plumbing systems don’t always get a lot of attention. That is until the pipeworks start to rupture, causing a nightmare. To steer clear of bathroom complications in the future, you may want to give your bathroom its much needed TLC before it’s too late.

You might also like More from author

Comments are closed.